Application / Suitable
| *Only suitable for 1/5 X-Maxx & 1/6 XRT & 1/10 Maxx & MAXX Slash of Traxxas. |
Specifications
| Torque At 6.0V | 55.7 kg-cm / 773.7 oz-in |
| Torque At 7.4V | 67.2 kg-cm / 933.4 oz-in |
| Torque At 8.4V | 73.9 kg-cm / 1026.5 oz-in |
| Speed At 6.0V | 0.12 sec / 60° |
| Speed At 7.4V | 0.10 sec / 60° |
| Speed At 8.4V | 0.08 sec / 60° |
Protection Mechanism
| Soft Start Protection | Soft start to a neutral position. |
| Over Voltage Protection | Over 9.0V drive the protection mode and 8.4V return to normal mode. |
| Low Voltage Protection | Lower than 4.0V, drive the protection mode and 4.5V return to normal mode. |
| Locked Rotor Protection | Stall in 5 sec, output torque goes down. |
| Temperature Protection | Overheat 85 degrees C (185 degrees F), drive the protection mode and down 75 degrees C (167 degrees F) return to normal mode. |
| Lose Control Protection | When losing the transmitter signal, that servo will be back to the neutral position immediately and lock. |
Power Supply
| Operating Voltage Range | 4.5V ~ 8.5V ( 4 ~ 6 Cell Ni-MH or 2S Li-Poly / 2S Li-Fe) |
Control Specification
| Control System | Higher-order Algorithm of【STMicroelectronics】32-bit MCU ( Microcontroller Unit ) Frequency：Up to 400Hz & 1500us or 1520us |
| Frame Rate (Signal repeat rate) | Under 1ms【Compatible with Futaba_UR/SR & Sanwa_SXR & KO_HCS Mode】 |
| Dead Band Width | 0.001ms ( Default：1us) |
Mechanical Specifications
| Ball Bearing | Dual, Stronger Ball Bearings with 1 piece of oil seal.【NMB from Japan】 |
| Gear | Stainless output shaft with Steel Alloy Metal Gears |
| Outside Case | Full One-Piece Aluminum CNC Casing |
| Motor | High Premium Brushless Motor |
| Horn / Gear Spline | 25 Teeth ( Same as Traxxas-Type ) |
| Connected Cable Length | 300 mm (11.81 in) [ Black Cladding Cable Edition ] |
Physical Specifications
| Dimension (mm) | 48.5 x 25 x 49.8 mm / 1.90 x 0.98 x 1.96 in |
| Weight (gram) | 121.8 ± 1 grams / 4.29 oz |
| Product Picture / Dimension Sketch |  |